background image

2

Important Safety Instructions and Precautions

WARNING:

DO NOT CONNECT DIRECTLY TO THE PUBLIC SWITCHED 

TELEPHONE NETWORK (PSTN). ANY CONNECTION OF THIS PHONE 

TO AN OFF PREMISE APPLICATION, AN OUT OF PLANT APPLICATION, 

ANY OTHER EXPOSED PLANT APPLICATION, OR TO ANY EQUIPMENT 

OTHER THAN THE INTENDED APPLICATION MAY RESULT IN A SAFETY 

HAZARD, AND/OR DEFECTIVE OPERATION, AND/OR EQUIPMENT 

DAMAGE. “EXPOSED PLANT” MEANS WHERE ANY PORTION OF THE 

CIRCUIT IS SUBJECT TO ACCIDENTAL CONTACT WITH ELECTRIC 

LIGHTING OR POWER CONDUCTORS OPERATING AT A VOLTAGE 

EXCEEDING 300 V BETWEEN CONDUCTORS OR IS SUBJECT TO 

LIGHTNING STRIKES.

WARNING:

THE SOCKET OUTLET, IF USED, SHALL BE LOCATED NEAR 

THE EQUIPMENT AND SHALL BE EASILY ACCESSIBLE BY THE USER.

WARNING:

USE MITEL APPROVED POWER ADAPTER PART NUMBER 

51015131.

NOTE:

SOME IP PHONES DO NOT REQUIRE AN AC POWER ADAPTER. IF 

POWER OVER THE LAN IS AVAILABLE, IT SHALL BE COMPLIANT WITH 

IEEE 802.3af.

WARNING:

THE HANDSET SUPPLIED WITH THE IP PHONE IS NOT 

CERTIFIED FOR USE WITH ANY OTHER PHONE. USE OF THE 

HANDSET WITH ANY OTHER PHONE MAY HAVE THE POTENTIAL TO 

CAUSE HEARING LOSS IN THE EVENT OF A LIGHTNING STRIKE ON 

THE OUTSIDE PLANT WIRING.
When using your phone equipment, basic safety precautions should always be 

followed to reduce the risk of fire, electric shock and injury to persons, including 

the following:
•  Do not use this product near water, for example, near a bath tub, wash 

bowl, kitchen sink or laundry tub, in a wet basement or near a swimming 

pool.

•  Avoid using a phone (other than a cordless type) during an electrical 

storm. There may be a remote risk of electric shock from lightning.

•  Do not use the phone to report a gas leak in the vicinity of a leak.
Maintenance and Repair: There are no user serviceable parts inside the 

phones. For repairs, return the phone to an authorized Mitel dealer.

These notices may appear on the product or in the technical documentation:

This symbol may appear on the product:

Description

Mitel 5320e/5330e/5340e IP phones are supported by:
• Mitel Communications Director (MCD) Release 5.0 and later software.
• SX-200 IP Communications Platform (ICP) Release 4.0 (UR3) and later 

software.

• 5000 Communications Platform Release 5.1 and later software.
5320e/5330e/5340e IP phones are LAN-powered.

Supporting Documentation

To access phone- and system-specific documentation:
1.  In your browser, go to http://edocs.mitel.com.
2. Click 

End User Documents

, and then select 

PDF

 

Guides and Online 

Help 

from the drop-down menu.

3. Navigate to 

5300 Series-Mitel Communications Director

.

Installing a 5320e/5330e/5340e IP Phone (See Figure 

)

NOTE:

The illustrations on the front page show a 5340e IP Phone; the 

following procedures also apply to the 5320e and 5330e IP Phones.
It is easiest to connect the cables to your phone after you have attached the 

mounting base unit to the phone.

Before installing your phone, ensure that you are familiar with the following 

powering options:
• An IEEE 802.3af LAN-powered jack provides power to the phone via a 

LAN cable. (The phone receives ethernet signals and power through the 

same cable.) To install, see Steps 

 and 

.

• An Ethernet power adapter provides power to the phone via a LAN cable. 

The Ethernet power adapter is connected to the LAN via a separate LAN 

cable connected to a jack. (The phone receives ethernet signals and 

power through the same cable.) To install, see Steps 

 and 

.

NOTE:

 Use only qualified Mitel-supplied Ethernet adapters.

Thread the LAN cable plug through the slot on the back of the installed base 

unit and plug it into the LAN port on the back of the phone.

NOTE:

If you are wall-mounting your phone, do not thread the LAN cable 

through the base unit slot—connect the cable directly from the LAN port on 

the phone to the jack on the wall.

Plug the other end of the LAN cable into 

one

 of the following:

• the phone port of an Ethernet power adapter. Then, connect the 

Ethernet adapter to the LAN using a separate LAN cable, and plug the 

power adapter into an AC power outlet.

or

•  a LAN-powered jack.

NOTE:

The LAN-powered phone provides power to any attached 

peripheral.

Plug the handset cord into the handset port and thread it through one of the 

slots on either side of the base unit.

(Optional) Plug the telephony headset cord into the headset port on the 

back of the phone. Thread the headset cord through one of the slots on 
either side of the base unit, as shown for the handset cord in 

above.

To register an installed phone to MiNET mode, enter a valid PIN, and then 
press 

  (HOLD) to register the phone.

After the date and time appear on the display, proceed with the next step.

For 3300 ICP MiNET deployments, you can connect a PC to the PC port on 

the back of the phone. If desired, thread the PC cable through the slot on the 

back of the installed base unit, as shown for the LAN cable in 

 above.

DANGER

Danger indicates an imminently hazardous situation which, if not 

avoided, will result in death or serious injury.

WARNING

Warning indicates a potentially hazardous situation which, if not 

avoided, could result in death or serious injury.

CAUTION

Caution indicates a potentially hazardous situation which, if not 

avoided, may result in minor or moderate injury and/or damage to the 

equipment or property.

The exclamation point within an equilateral triangle indicates that important 

operating and maintenance (servicing) instructions are included in the 

literature accompanying the product.

!

A

Summary of Contents for MiVoice 5340e









Reviews: