36
Mirka® LEROS Random Orbital Sander • 225 mm (9") • 100–240 V & 110 V
WARNING
• Always wear required personal safety protection in accordance with manufacturer’s instructions and local/national
standards while using this tool .
• The electrical safety of the tool is ensured only by using original Mirka backing pads .
• Do not use a power tool while you are tired or under the influence of drugs, alcohol or medication .
• Read the Materials Safety Data Sheet (MSDS) for the work surface .
• Use the tool with dust extraction . A suitable dust extraction unit will reduce hazardous dust .
• Do not overreach . The operator must always stand in a secure position with a firm grip and firm footing on a solid
floor .
• Do not wear loose clothing or jewelry . Keep hair, clothing and gloves away from moving parts . Loose clothes, jewelry
or long hair can get caught in moving parts .
• If any physical hand/wrist discomfort is experienced, stop working and seek medical attention . Hand, wrist and arm
injury may result from repetitive work, motion and overexposure to vibrations .
• Do not operate power tools in explosive atmospheres, such as in the presence of flammable liquids, gases or dust .
Power tools create sparks which may ignite the dust or fumes .
CAUTION
• Keep work area clean and well lit .
• Before changing the abrasive always disconnect the power source . Make sure the abrasive is perfectly centered and
firmly attached to the backing pad .
• Keep children and bystanders away while operating a power tool . Distractions can cause you to lose control .
• Always pay attention to work safety . Never carry, store or leave the tool unattended with the power source
connected .
• Keep hands clear of the spinning pad during use .
• Do not allow the tool to free speed without taking precautions to protect any persons or objects from the loss of the
abrasive or backing pad .
• Do not use in wet conditions .
Additional safety warnings
• Read all instructions before using this tool . All operators must be fully trained in the proper, safe use of this tool .
• Always refit the cover cap after installing the backing pad .
• All maintenance must be carried out by trained personnel . For service, contact a Mirka authorized service center!
• Always use the tools with a residual current device (RCD) with a rated residual current of 30 mA or less .
• The power supply socket and connector are non-IEC appliance couplers . Only use an original Mirka power cord . The
Mirka power cord can be bought from your Mirka Dealer .
• Check the tool, backing pad, power cord and fittings regularly for wear .
• Clean or replace the dust extractor’s collection bag regularly . Dust can be highly combustible . Cleaning or replacing
the bag also assures optimum performance .
• Always ensure that the power tool specifications correspond to the power source (V, Hz) .
• Take care to prevent clothing, ties, hair, cleaning rags, etc ., from getting caught in the tool’s moving parts .
• If the tool appears to malfunction, stop using it immediately and arrange for service and repair .
Additional warnings
Some dust created by power sanding, sawing, grinding, drilling, and other construction activities contains chemicals
known to cause cancer, birth defects or other reproductive harm . Some examples of these chemicals are:
• lead from lead-based paints,
• crystalline silica from bricks and cement and other masonry products, and
• arsenic and chromium from chemicallytreated lumber .
Your risk from these exposures varies, depending on how often you do this type of work . To reduce your exposure to
these chemicals: work in a well ventilated area, and work with approved safety equipment, such as those dust masks
that are specially designed to filter out microscopic particles .
en | us • ca
