QDV-1000 Voice Message Recording Procedure
Equipment Required:
1. Personal Computer with sound card.
2. Audio cable with mini stereo plug at both ends (to plug into the computer and the stereo jack of the QDVP-
100.
3. Wire to 24V D.C. power supply such as Filtered smoke detector supply voltage at the Fire Alarm Panel or
24V DC transformer with power cord with 2 pin plug OR 2 wires to be connected to the QVDP-100
Configurator power supply pins (remove terminal block) or terminal block.
4.
QDVP-100
Configurator.
5. Small 8 ohm speaker (optional).
Software Required:
1. Any of the following software: Real Player, Windows Media Player or Windows Sound Recorder.
2. The sound clip files to be recorded.
3. Sound clip file SO-195.wav, the 5 seconds of pre-announcement tone.
LT-901 Rev.4 Aug 2006
Page 3 of 10
Procedure:
Setting Up QDVP-100:
1. Plug one end of the audio cable into the audio
input of
QDVP-100 Configurator
, refer to
diagram.
2. Plug the other end of the audio cable to the
audio out or speaker out of the personal
computer.
3. Connect the DC 24V power supply to terminals
24V DC of the
QDVP-100
Configurator
, see diagram at right.
4. Connect the optional speaker to terminals
marked S and - on the
QDVP-100
Configurator
, see diagram.
5. Verify that the ribbon cable at J2 on the
QDV-
1000
module is not connected to QIF-5000B at
this time.
6.
Plug the ribbon cable from the
QDVP-100
to
J1
of the QDV-1000.
Summary of Contents for QDV-1000
Page 11: ......
