Mircom EP-825, Installation And Operating Instructions Manual

Page: 7 / 11

OPERATING INSTRUCTIONS FOR EP-825 RADIO INTERCOM
MASTER STATION
Adjust STATION VOLUME fully clockwise. To CALL an inside station, press the INSIDE
button and talk into the master speaker at a normal voice level. The call will be heard at all inside
stations that are turned on and not being monitored.
To
ANSWER
from a remote station, press the
INSIDE
button and speak at a normal voice level. The
reply will be heard at all remote stations and the master if they are turned on. To
ANSWER
the door
station, hold down the OUTSIDE button and speak at a normal voice level.
Note: The intercom level can be increased or decreased by adjusting SVR02 on the Amplifier Board.
To
ANSWER
the door station, hold down the
OUTSIDE
button and speak into the Master station at
a normal voice level. Release the Outside button to hear the reply. The reply is automatic and does not
require the operation of any controls. When answering the door the radio is automatically silenced, but
will resume its operation approximately 10 seconds after releasing the
OUTSIDE button.
REMOTE STATIONS
Turn
VOLUME
control fully clockwise. To
CAL
L, press the
INSlDE
button and talk into the speaker
at a normal voice level. The call will be heard at all remote stations and the Master if they are turned on.
To
ANSWER
from a remote station, press the
INSIDE
button and speak at a normal voice level. The
reply will be heard at all remote stations and the master if they are turned on. To
ANSWER
the door
station, hold down the OUTSIDE button and speak at a normal voice level. To LISTEN, press the
MONITOR
button on the remote station or Master. Sounds originating from the room in which the
station is located will be heard at all remote stations that are turned on, or at the Master if the STATION
VOLUME
is turned on. To release the
MONITOR
button, push the
INSIDE
button momentarily.
DOOR STATION
To CAL L, push the button located on door station. Depending on the connection either a single or a
three note chime will be heard at all stations that are turned on. (3 notes if connected to
Z2
, one note if
connected to
Z1
) The chime level can also be increased or decreased by adjusting
SVR03
on the
Master Station Amplifier P.C Board.
RADIO OPERATION
Master
By pressing
AM/FM button the AM1, AM2, FM1, FM2 or FM3 presets can be selected.