24
1st Beep (LONG) - Release
START/STOP
.
2nd Beep (SHORT) - Release
FLOW
.
4.
5. HIGH FLOW LIGHT FLASHES
This indicates shower is commissioning correctly.
Water flows for approximately 1 minute 20 seconds.
In some cases the cycle can take up to 3 minutes.
Allow shower to stop automatically.
IMPORTANT! DO NOT INTERRUPT THE CYCLE!
6.
Push
START/STOP
to turn shower
ON.
Check that maximum temperature is
acceptable to the user.
COMMISSIONING FAILURES
(the commissioning cycle was stopped due to an error)
No flashing FLOW LIGHT...
solution
...Restart the commissioning cycle.
No water after 5 seconds...
solution
...Reprime the shower. (See "Installation".)
WATER SUPPLY or
RESET light is on................
solution
...Reprime the shower. (See "Installation".)
_
+
7.
Push
START/STOP
to turn shower
OFF
.
Wait until water has stopped flowing
BEFORE
turning Power/Electric
OFF
.
8.
Residual water may drain over a few
minutes.
OFF
Summary of Contents for Advance ATL J97A
Page 39: ...39 NOTES...
