Miomare 354945 2004, Assembly, Operating And Safety Instructions

Page: 10 / 34

10 GB/IE
or household fittings and furniture. Check all
connections for leaks carefully.
Ensure that all seals are correctly seated to pre­
vent leakage of water.
The spout can be swiveled to your desired
position. Make sure the spout is always posi­
tioned within the area of the sink, otherwise
escape of water can lead to serious flooding
to your house or building.
CAUTION! DANGER OF SCALDING!
When making the hot water setting please
ensure that the temperature of the water is not
too high.
Before installation, make yourself familiar with
all the existing services, e.g. water connection
and stopcocks.
Please read carefully through these operating
instructions before installing and using the
product. Keep all the safety advice and instruc­
tions in a safe place for future reference!
Installation
Installing the tap
Turn off the main water supply to prevent serious
leakage of water. Allow any remaining water
in the pipework to drain.
Install the tap as shown in Fig. A‒E.
CAUTION! Do not bend the hoses or place
them under tension. Otherwise material dam­
age could result.
Flushing the tap
The tap must be flushed through before first use
to remove any dirt. To do this, follow these
steps (see Fig. F):
Screw the gasket
18
, aerator insert
19
and
aerator cover
20
off.
Open the main water supply and allow the
water to run for two minutes.
Then screw the gasket
18
, aerator insert
19
and aerator cover
20
on again.
Water-saving function
The cartridge
12
in this tap has an Eco­Click
function. This feature limits the water flow through
the tap (see Fig. H).
Lift the lever
17
until you notice a slight resist­
ance. This resistance will cause a stop in case
of partial opening and will therefore simply limit
the flow of water.
If you want to increase the flow rate, exert slight
pressure on the lever
17
until you overcome the
resistance.
Operation
Bringing into use
Note: If the tap has not been used for a long pe­
riod flush the pipes through thoroughly in order to
avoid stagnation and build­up of residues in the
drinking water supply.
Open the main water supply.
Lift the control lever
17
and swing it to the right
or left in order to regulate the speed or temper­
ature of the water flow.
Maintenance and cleaning
Tap care and cleaning
Please note that sanitary fittings require special
care and attention. Therefore you should follow
the following advice:
Never use corrosive or alcohol­based materials
for cleaning, as these could damage the product.
Clean your fittings with clean water, mild deter­
gent and a soft cloth or leather only.
Screw out the gasket
18
, aerator insert
19
and
aerator cover
20
at regular intervals and re­
move lime deposits or foreign bodies.
Non­observance of the above care advice can
be expected to result in damage to the surface
of the fittings. In this event your rights under the
warranty may be invalidated.