7
GB/IE/NI
m
CAUTION!
Change the temperature limiter
setting only after the tap has been installed.
Follow Fig. I to set the temperature limitation.
Turn off the main water supply.
Remove the hot / cold plaque
3
carefully by
a small flat screwdriver.
Release the locking screw
2
by turning it
anticlockwise using the hexagonal key
7
.
m
CAUTION!
Do not take the screw
2
completely out; just loosen it until the control
lever
1
can be easily taken off.
Take off the control lever
1
.
Loosen the cartridge covering ring
20
by
hand, then screw off the cartridge retaining
ring
21
by using a pipe wrench.
Now pull the adjusting ring
22
upwards with
the help of a screwdriver.
Note:
Do not remove the cartridge
23
.
Place the adjusting ring
22
in the desired
position (see Fig. I).
Tighten the cartridge retaining ring
21
onto
the tap body
5
again by using a pipe
wrench. Then tighten the cartridge covering
ring
20
by hand.
Place the control lever
1
back on to the
tap body
5
. Tighten the locking screw
2
by turning it clockwise using the hexagonal
key
7
.
Press the hot / cold plaque
3
into the
opening.
Turn on the main water supply and check the
temperature limiter.
§
Maintenance and cleaning
§
Tap care and cleaning
Please note that sanitary fittings require special
care and attention. Therefore you should follow
the following advice:
Never use corrosive or alcohol-based
materials for cleaning, as these could
damage the product.
Clean your fittings with clean water, mild
detergent and a soft cloth or leather only.
Screw out the aerator
24
at regular intervals
and remove lime deposits or foreign bodies.
Non-observance of the above care advice can
be expected to result in damage to the surface
of the fittings. In this event your rights under the
warranty may be invalidated.
§
Disposal
The packaging is made entirely of recyclable
materials, which you may dispose of at local
recycling facilities.
Contact your local refuse disposal authority for
more details of how to dispose of your worn-out
product.
Summary of Contents for 310979
Page 4: ...E 10 11 8 9 15 27 max 32 mm 10 11 15 8 9 max 50 mm...
Page 5: ...F...