Page 8
Parts and Instruction Manual - MR1500/MR2000 Burnisher
MAINTENANCE
MAINTENANCE:
This BURNISHER has been engineered and built to require minimum maintenance. But like any
machine, it does require some care to keep it in optimum working condition. Careful attention to these
maintenance instructions will give you maximum operating performance and life expectancy of the
machine.
CAUTION: Disconnect the power cord from the outlet before doing any clean up or maintenance
on the machine
t
Keep the machine clean. Do not allow dust to accumulate on external surfaces, the motor, or near any
moving parts.
t
After every job, wipe down the surface of the ma- chine with a clean damp cloth.
t
Inspect cord for damage. Do not use machine with a damaged cord.
CORD STORAGE:
While not in use, storage can be accomplished by winding cord around handle assy. Cord should be
completely unwound during operation.
CORD SAFETY
t
Do not leave appliance when plugged in. Unplug from outlet when not in use and before servicing
t
Do not use with damaged cord or plug. If appliance is not working as it should, has been dropped,
damaged, left outdoors, or dropped into water, return to service center for inspection and repair.
t
Do not pull or carry by cord, use cord as handle, close a door on cord, or pull cord around sharp
edges or corners. Do not run this BURNISHER over cord. Keep cord away from heated surfaces.
t
Do not unplug by pulling cord. To unplug, grasp the plug, not the cord.
t
Do not handle plug or appliance with wet hands.
t
Always unplug the machine when removing brush.
t
This equipment should be stored indoors and not exposed to rain.
CLEAN UP & STORAGE
t
Unplug and wrap it under the cord hook and around the left side handle grip. Clean the cord and
inspect it for cuts, gashes and loose prongs.
t
Wipe down the machine and store in clean dry place.
