M I N T R O N I X C O M P U T E R S O L U T I O N S
124 Old Mill Road, Suite H
Greenville, SC 29607
855-672-6464
Page 24
Version 1-2018
33.1 Reader Test
The following process will test MSR213U installation:
1.
Run the Notepad application from Start ? Programs ? Accessories ? Notepad
under Windows
2.
Swipe any card through the reader MSR213U.
3.
The card data should appear on the Notepad if the MSR213U installed properly.
33.2 Changing Configuration
The MSR configurations can be changed through software installed on the system.
They are factory preset and normally do not need to be changed by the user.
To enter the setting mode:
Connect keyboard to your MP5000i5v2 computer.
Run .MSR213U setting AP
Follow instructions on the screen to change settings
33.3 Optional 2x20 LCD Character Display
The 2x20 character display is an alpha numeric LCD with back light. It is driven by a
serial interface controller and normally set at COM4. The board receives control and
character codes which are then displayed on the LCD. This is a receive-only device.
33.4 Power-Up Initialization
Upon power-up, the controller goes into its initialization sequence. The board is
designed to initialize in two states:
1.
physical power up
2.
software power up.
After 250mS, the board is ready to receive software power up.
YOU
MUST
SEND THE
BOARD A CLEAR SCREEN COMMAND (HEX 0C) TWO TIMES AT HALF SECOND
INTERVALS.
This will initialize the controller completely. The LCD display is
NOT
hot
pluggable or hot swappable!
