4.
Fully open both legs and place
MagRide60 on a flat and level
floor.
At this moment, make sure all 4
foot are contacting the floor at
once to sit on the floor stable.
(see Fig. B)
The magnetic resitance unit is pre-installed on the
main frame.
To adjust the tightening of the M6x50 bolt and the
M6 nut, use a hex wrench and spanner.
- 3 -
Replace your rear wheel quick release skewer with the supplied one.
Minoura guarantees the stability only when using the supplied skewer due to the coupling inner shape.
!
If your bike is not equipped with quick release skewer and it's a hub nut type, you
should remove the black plastic Grommet (skewer nut protector) from the right side
coupling. Minoura doesn't guarantee the stability if you don't remove the Grommet.
You don't need the supplied quick release skewer if your
wheel is a hub nut type.
It's not possible to convert your wheel from the hub nut type
to the quick release skewer type unless you replace the hub.
!
Required Tools:
1 x 10mm Spanner / 1 x M4 Hex Wrench
!
Make sure the acorn shaped spring
direction is as shown in Fig. A-2.
Failure to do so will cause operational
issues.
(Fig. A-2)
(Fig. B)
!
Use caution when tightening the
M6x50 bolt.
If it's too tight the mag unit will not
move smoothly.
If it's too lose your may pinch your
finger.
Roller Pressure Adjust Knob
M6x50 Bolt
Acorn Spring
(Fig. A-1)
(Tools are not included. Please prepare separately)
Plate Nut
How To Setup Your MR60 Trainer
Flat Washer
Grommet
Install the Roller Pressure Adjust
Knob set to the Plate Nut coming
from behind the bracket on the
frame. (see Fig. A-1)
1.
2.
3.