ϯ͘hƐŝŶŐdŚĞĂŵĐŽƌĚĞƌ
3. Select
‘Time
-
Lapse’
using the UP or DOWN buttons and press the OK
button to enter the
‘Time
-
Lapse’
submenu.
4. Press the UP or DOWN buttons to navigate the menu, and press the
OK button to confirm your selected setting (
Off, Interval of 0.5
Seconds, 1 Second, 2 Seconds, 5 Seconds, 10 Seconds, 30 Seconds,
60 Seconds
).
NOTE: By selecting
’10 Seconds’
the camera will capture one photo
every 10 seconds and create a time-lapse video. To disable Time-Lapse
recording, select ‘
Off’
in this submenu.
3.1.4 Loop Recording
This function allows you to set a maximum duration for each video clip recorded.
1. In Video Mode press the MODE button until you enter the Options Mode.
2. Press the OK button to enter Video Setup mode.
3. Select
‘
Loop Recording
’
using the UP or DOWN buttons and press the OK
button to enter the
‘
Loop Recording
’
submenu.
4. Press the UP or DOWN buttons to select the required loop duration
option (
Off, 2 Minutes, 3 Minutes, 5 Minutes
), and press the OK button
to confirm your selected option.
Once you select an option, your camcorder will record video clips in this
interval only. Once this duration is reached, the camcorder will seamlessly
end recording and begin recording a new video file.
3.1.5 Slow Motion
This function sets the frame rate of the recorded video to a much slower
rate.
1. In Video Mode press the MODE button until you enter the Options
Mode.
2. Press the OK button to enter Video Setup mode.
3. Select
‘
Slow Motion
’
using the UP or DOWN buttons and press the OK
button to enter the
‘
Slow Motion
’
submenu.
4. Press the UP or DOWN buttons to navigate the menu, and press the OK
button to confirm your selected setting (
1080P 60fps, 720P 120fps
).
3.1.6 EIS (Electronic Image Stabilization)
This setting enables image capture in shaky or low-light settings by
electronically eliminating motion blur and canceling shake.
1. In Video Mode press the MODE button until you enter the Options Mode.
2. Press the OK button to enter Video Setup mode.
3.
Select ‘
EI
S’
using the UP or DOWN buttons
4. Press the OK button to turn Electronic Image Stabilization On or Off, if the
box has a check mark then Electronic Image Stabilization is On.
