32 | minnkotamotors.com
©2018 Johnson Outdoors Marine Electronics, Inc.
INSTALLING AN EXTERNAL TRANSDUCER
An external transducer is not included with your trolling motor. An external transducer can be installed onto motors that have Universal
Sonar or motors that do not have a built in transducer. For more information on Universal Sonar, please visit
Installing an external transducer is not recommended for motors with Built-in MEGA Down Imaging.
INSTALLING AN EXTERNAL TRANSDUCER
a. Mount the External Transducer according to
directions provided with the transducer.
b. Leave enough slack in the Transducer Cable between
the Lower Unit and Control Head to allow the motor
to properly stow and deploy.
c. Use two tie wrap cables to secure the Transducer
Cable to the Shaft just above the Lift Assist Collar
and just below the Control Head.
d. Run the Transducer Cable through the Coil Cord to
the power supply.
Slack
Tie Wrap Cable
Lift Assist Collar
Lower Unit
Tie Wrap Cable
External Transducer
Transducer Cable
Coil Cord
Control Head
1
CAUTION
Not following the recommended wire routing for the Universal
Sonar and External Transducer Cables may cause damage to
the product and void your product warranty. Take care to test
the length and placement of cable to be sure that there is
enough slack where needed and that cables are free of being
entangled in moving parts. Routing the cables in any way
other than directed may cause damage to the cables by being
pinched or severed.
