minnkotamotors.com | 15
©2018 Johnson Outdoors Marine Electronics, Inc.
ROUTING UNIVERSAL SONAR &
i
-PILOT LINK CABLES
a. Place the motor in the deployed position.
b. Locate the Built-in MEGA Down Imaging, i-Pilot Link
and/or Universal Sonar cable(s), at the base of the
Control Head.
c. The cable(s) should be fed all the way through the
Coil Cord. It/they should exit the Coil Cord at the
bottom of the Coil Cord, where it connects to the
Mount.
NOTICE:
After the cable(s) exit(s) the Coil Cord, it/they
should be routed through an established routing system on
the boat, in an area with minimal interference. Power cables
or other elements that may produce interference for the sonar
signals. Inspect the selected route carefully to ensure that
there are no sharp edges, obstacles, or obstructions that may
damage the cables.
CAUTION
Not following the recommended wire routing for the Built-in
MEGA Down Imaging, i-Pilot Link and/or Universal Sonar
cable(s), if equipped, may cause damage to the product and
void your product warranty. Route cables away from pinch
points or other areas that may cause them to bend in sharp
angles. Routing the cables in any way other than directed may
cause damage to the cables by being pinched or severed.
1
2
Control Head
Coil
Cord
Mount
i-Pilot
Link
Control
Head
Coil Cord
Mount
Built-in MEGA
Down Imaging or
Universal Sonar
One Connection
Two Connections
Built-in MEGA
Down Imaging or
Universal Sonar
Control Head
Coil Cord
i-Pilot
Link
Control Head
Coil Cord
Built-in MEGA
Down Imaging or
Universal Sonar
One Connection
Two Connections
Built-in MEGA
Down Imaging or
Universal Sonar
NOTICE:
Universal Sonar connector shown for
illustration purposes.
Universal Sonar
Connector
