minnkotamotors.com | 21
©2015 Johnson Outdoors Marine Electronics, Inc.
mAnUAL COnTROL
TRImmIng UP AnD DOWn
There will be times when you will need to move your motor up or down depending on how your boat is responding. You
can trim up to avoid hitting underwater objects and you can trim down if your prop is coming out of the water. Trim the
motor up or down with the i-Pilot remote by pressing
or
.
NOTE:
The prop will temporarily stop while trimming the motor and resume once trimming is stopped.
NOTE:
Trim limits are in place to avoid damage to the unit. An upper trim limit is set 12” from the bottom of the motor
mount to the center of the motor. A lower trim limit is set approximately 1.5" from the bottom of the control head to the
trim housing.
NOTE:
A prop lockout region, defined as 17” from bottom of motor mount to center of motor, is used to eliminate the
possibility of the motor contacting the boat hull. All functions with the exception of manual steer and track record are
canceled upon trimming into this region.
sTOWIng & DEPLOYIng
To deploy the motor with the i-Pilot remote,
double press
.
Pressing the button while deploying will stop the sequence. A second button press will reverse the
deploy sequence. Upon deploy the motor will return to its last trim length.
To stow the motor with the i-Pilot remote, press
.
Pressing the button while stowing will pause the sequence. If the motor shaft is still vertical a second
button press will continue the stow cycle. If the motor shaft is not vertical a second button press will
redeploy the motor and return it to its last known trim position.
NOTE:
The deploy sequence can be stopped at any time pressing the stow/deploy button. The stow
sequence can be stopped at any time by pressing either trim button or the stow/deploy button.
HIgH sPEED bYPAss OPERATIOn
Engage
Pressing
will set the motor speed to maximum immediately.
Disengage
Pressing
again will set the motor speed to the value it was at previously.
NOTE:
High Speed Bypass does not enable or disable the prop.
LCD bACKLIgHT bUTTOn
To turn on LCD backlighting press and release
.
The backlight will turn off eight seconds after the last button press to conserve battery power.
Trim Up/Down
Stow/Deploy
