4 | minnkotamotors.com
©2020 Johnson Outdoors Marine Electronics, Inc.
Installation with an Atlas Hydraulic Jack Plate
1a
2c
Mounting
Holes
Mounting
Holes
Hex Head
Cap Screws
Heavy Duty
Washers
Port
Bracket
a. Locate the Mounting Holes on the side of the Atlas
Jack Plate Bracket. The Mounting Holes may be
located under the Jack Plate decal.
b. Take the Port Jack Plate Bracket (Item #2 or Item
#4) and align it with the Mounting Holes in the Port
side of the Jack Plate. Orientate the Port Bracket
so that the Red Retainer is facing Outboard and the
Slotted Mounting Hole is upward.
c. With the Port Bracket aligned, take two 3” Stainless
Steel Hex Head Cap Screws (Item #18) and two
Heavy Duty Stainless Steel Washers (Item #14).
Place one Heavy Duty Washer on each of the Hex
Head Cap Screws. Apply anti-seize on the threads of
the Hex Head Cap Screws (Item #22).
d. Insert the Hex Head Cap Screws with the Heavy Duty
Washers in place through the Mounting Holes in the
Port Bracket and into the Mounting Holes on the Port
side of the Jack Plate.
e. Take two Heavy Duty Stainless Steel Washers (Item
#14) and place one on the end of each Hex Head
Cap Screw on the inside of the Jack Plate. Secure
the hardware with two Stainless Steel Nylock Nuts
(Item #16). Hold the Nylock Nuts with a 1/2” Open
End Wrench and tighten the Hex Head Cap Screws
with a 1/2” Socket Wrench. Check with your specific
equipment manufacturer for their recommended
settings. Tighten hardware to 50 ft-lbs.
f. Continue to the “Completing the Installation” section
of these instructions.
1
2
ITEM(S) NEEDED
NOTICE:
To prevent seizing of the stainless steel
hardware, do not use high speed installation tools.
Applying an anti-seize may help prevent seizing.
#22 x 1
#16 x 2
#18 X 2
#14 x 4
1b
2e
Red Retainer
Mounting
Holes
Outboard
Outboard
Slotted
Mounting
Hole
Heavy Duty
Washers
Nylock
Nuts
ITEM(S) NEEDED
#2 x 1
#4 x 1
