MINITECH
CNC Mini-Mill User's Guide
Computer Interface Connection
The Mini-Mill is controlled by a PC based computer. This means that the signals used to
control the table movements and other operations are all controlled by the computer. The
Mini-Mill system is supplied with a USB cable with the same type of connector at each end. It
is a standard cable which can be purchased at any computer outlet, if you should misplace
this item.
Do not attempt to connect the interface cable while either the computer or Mini-Mill is
powered on. This may cause electronic failure to These electronic components. For your
safety and the integrity of the equipment, turn all devices off prior to making any interface
connection.
Setup the computer to be used with the machine and install the controller software. Refer to
the
CNC Stepper Motor Control Box CS5SA8-1
manual for installation instructions. If at
anytime you experience inconsistent table motions, or no table motions at all, check this cable
to make sure it is properly installed.
© 2012 Minitech Machinery Corp. 10
