20
※
※
Dualtron X User Manual
Maintenance
Important
notice
Easy-wheel
system
Maintenance by self-maintenance
1. Brake adjustment method
2. Tire replacement method
•
While driving, metal sounds from motor vibrations, tremors from brake discs and pads, etc., may occur
in the accelerating load range (torsional vibration). (About 150~30Km, depends on the product) This is a
phenomenon in which vibrations occur at a certain rpm of all rotating bodies (fans, cars, ships, etc.) that are
not abnormal. However continuous noise or a loud metal sound, there is a possibility of deformation such as
bending of the disk. You need a regular checkup.
•
After driving, be careful as there is a risk of burns due to the heat on the motor and brake (especially the disc
rotor) side.
•
Please note that the bolts of motor, rim, motor shaft and other fixing parts can be loosened by ABS function.
•
When removing and assembling the side cover for checking and repairing for the light, charging port, power
switch, etc. please use standard bolt and tight carefully to avoid the sheathing of wiring. If tightening with a
bolt other than the standard bolt (long bolt), the battery case(battery cell) may be fatally damaged, resulting
in a fire or safety accident.
•
Completely separable hub motor design By designing the rim and hub motor to be completely
separable it is possible to replace only the rim without replacing the entire motor when the rim
breaks, thus improving the maintenance and maintenance of the product. (Patent)
•
After completing the tire replacement, try a simple test run with the appropriate air pressure.
•
When puncture is occurred, it is possible to use repair by using patch seal. Please use the tire while
checking and checking continuously
Due to the nature of the product, the folds and joints where movement occurs can be easily
damaged during use.Especially, this can happen when operating with inaccurate behavior or form.
When checking the product, keep the two wheels off the ground and work on a safe work surface.
If the brake is used for a long time such as downhill or if
the brake braking force decreases due to overheat of oil,
malfunction of oil hose, loosening of the brake lever or oil
leakage, etc. stop using it and
please visit the service center before use.
1. After removing the calipers, remove the motor using 18mm
spanner and disassemble the wheel and motor fastening bolts.
2. Remove the wind from the tires and press the tires off the
wheel.
3. Replace the tires and complete the assembly of the tires in
reverse order. Tighten the assembled tire to fit the body, then
tighten the screws and bolts.
* Caution
