24
5.2.11. Alarm out of range
If the connection between the parents’ unit and the baby unit is lost at any time, both LEDS
indicating the sound level of the parents’ unit will flash alternatively red for 20 seconds to indicate
that the baby unit is being looked for and the temperature (G) will stop being shown, with two
horizontal lines flashing in its place on the display. If, after these 20 seconds, the connection is
not re-established (the beacon signal is not received which is sent by the baby unit), the charging
and on LED indicator (9) will flash red and green alternatively whilst the parents’ unit emits a
beep with three tones and the coverage indicator symbol (I) will also flash by way of a warning.
In the latter case, to re-establish the link between both units, make sure that the parents’ unit
falls within the coverage radius of the baby unit (bring the units closer to each other and wait
for around 5 seconds) and make sure that both units are on. If the link is not re-established, this
means that the baby and parents’ units have lost their connection and it must be re-established.
5.2.12. Connection of the units (pairing)
If the connection between both units has been lost and it is impossible to re-establish it by
following the indications of the previous paragraph above, please follow the steps provided for
pairing the parents’ unit with the baby unit: simultaneously press the on/off buttons of both units
(1 and 18) for 3 seconds with both units initially off. Both units must be automatically linked.
5.3. GUIDE TO IDENTIFYING AND CORRECTING POTENTIAL PROBLEMS
Problem
Possible cause - things to do/check
There is no signal in the
parent unit
· The AC/DC adapter has not been connected to the baby unit.
Connect the adapter.
· The baby unit is off. Turn it on.
· The parent unit is off. Turn it on.
· The parent unit batteries are running low or are already flat.
Place the parent unit on the charger base in order to recharge
the batteries.
· The parent unit is out of range of the baby unit. Move the
two units closer together and wait for 5 seconds until the
link is reestablished. Pair both units again if necessary (see
item 5.2.12.)
· The baby unit is not detecting any sound in the room and
has entered standby mode. The transmission of sound will
recommence when the baby unit detects a sound above the
sensitivity threshold.
The LED on / off and charge
indicator (4) on the parent
unit flashes in green and
red alternately and emits a
three-tone beep. The sounds
captured by the baby unit
cannot be heard.
· The parent unit is out of range of the baby unit. Move the
two units closer together and wait for 5 seconds until the link
is reestablished.
· The connection between the parent and baby units has been
lost. The two units need to be paired again (see item 5.2.12.).
· The baby unit is off. Turn it on.
The baby unit cannot be
heard from the parent unit,
but the LED on / off and
charge indicator (4) is green.
· The volume on the parent unit is turned right down. Raise the
volume by pressing the button (2).
ENGLISH
