SMART CAT5 SWITCH 16 IP
.
45
0.0.0.0/0 matches any IP packet
Policy
- Determines what to do with matching packets. They are accepted or
dropped.
NOTE: The order of the rules is important. The rules are checked in ascending
order until a rule matches. Rules below the matching one are ignored. The default
policy applies if no match has been found.
Append a rule
– To add a rule to the end of the rule list: Enter the IP/Mask and
set the policy. Then press
.
Insert a rule
- To insert a rule according to the rule number: Enter the rule
number, IP/Mask and set the policy. Then press
. All rules with higher
numbers are shifted below.
Replace a rule
- Enter the rule number, IP/Mask and set the policy. Then press
.
Delete a rule
- Enter the rule number and press
.
Anti Brute Force Settings
Anti Brute Force Settings
lets you block access to a specific user, for a fixed
amount of time if a predefined number of unsuccessful login attempts by this user
occurred.
Max. number of failed logins
– insert a maximum number or leave it blank to
disable Anti Brute Force.
Block time
- Block time in minutes - insert a number or leave it blank.
To unblock blocked users. Connect to the Smart 16 IP Serial 1 port using terminal
software, and type
unblock
. A list of blocked users appears. Select the users to
unblock.
33. SNMP Settings
The following information is available via SNMP:
•
Serial number
•
Firmware version
•
MAC address / IP address / Netmask / Gateway of LAN interface
•
Configured users
Summary of Contents for 5UM20114
Page 87: ...OPERATING GUIDE 86 ...