0088-3 x 5
0004 x 1
M4 Washer
Hardware for
these assemblies
0088 x 8
M3x8 Tapered
Socket Bolt
Servo
Arm Not
Included
0059-3
131-148
0116
0017-2
121-6
0133-1
0133-1
0015
0103
0103 x 1
M2 Threaded Steel Ball
0015 x 1
2mm Hex Nut
0017-2 x 1
2.5mm Hex Nut
0116 x 1
M2.5 Threaded Steel
Ball
0059-3 x 4
M2.5x10 Socket Bolt
Assembly Tips
• Throttle linkage length is only an
estimate. Linkage lengths will very
depending on motor and servo brand.
• Use shim washer 0620-01 (0.1mm), -02
(0.2mm) and/or -03 (0.3mm) to set gear
mesh for crown gear 0866-5-B. After
Main Shaft is bolted to the Main Gear,
adjust Bottom Main Shaft Bearing Block
to eliminate any vertical play. Tighten
Bottom Bearing Block bolts. Take care
that the Bottom Main Shaft Bearing
Block is horizontal ausgerichtet. Now
check gear mesh of crown gear. If
necessary remove or add 0620-0x shim
washers. Gear mesh should be about
0.1mm.
64.5mm
132-117-B
Apply a small amount of
medium thread lock when
threading into metal parts
131-467
131-426
131-424
131-469-1
131-470
131-419
131-419
0088 x 8
131-466
0620-01, 0620-02,
0620-03 as required
3-E
0021
131-202
0021 x 1
M4 Hex Locknut
131-202 x 1
M4 Jesus Bolt OWB V2
0088-3 x 5
M3x7 Tapered
Socket Bolt
27
