Mini Pro Chassis Dyno V2, Instruction Manual, Page: 13 / 24

12
1. (-) ESC Conn. (Black)
2. (+) ESC Conn. (Red)
3. Electronic Board Conn. - Current
4. Electronic Board Conn. - Voltage
5. Electronic Board Conn. - Ground
6. (+) Battery Conn. (Red)
7. (-) Battery Conn. (Black)
Please refer to the ESC, Transmitter, and Receiver manufacturers’ instruction manual.
Connect the sensor in the electronic board with the provided cable.
Solder connectors of your preference
OR 14 gauge wires
ELECTRONIC CONNECTIONS
Connect Transmitter, Receiver, and ESC to the Motor
Connect Sensor
Connect Sensor to Electronic Board
2
3
4
Voltage and Current Sensor Diagram
Solder Connector
1
7
6
2
5
4
3
1
5
4
3
Voltage and Current
Board Diagram
miniPRO A1 Voltage and Current Sensor Connection
1
2
3 1
2
3
CONT.
3.1. Connect the battery to the sensor’s
battery connector.
3.2. Connect the ESC’s battery port to the
sensor’s ESC connector. See above sensor
diagram for more information.
3.3. Turn ON the ESC and make sure it powers
on.
If the sensor starts to overheat, discon-
nect the battery immediately.