Mini Pro Chassis Dyno V1, Instruction Manual

Page: 9 / 21

8
1. (+) Battery Conn.
2. (-) Battery Conn.
3. (-) ESC Conn.
4. (+) ESC Conn.
5. Electronic Board Conn. - Ground
6. Electronic Board Conn. - Voltage
7. Electronic Board Conn. - Current
NOTE:
This diagram applies to the 50A, 100A, and 200A sensor.
Please refer to the ESC, Transmitter, and Receiver manufacturers’ instruction manual.
3.1. Connect the ESC’s battery port to the
sensor’s ESC connector. See above sensor
diagram for more information.
3.2. Connect the battery to the
sensor’s battery connector.
3.3. Turn ON the ESC and make
sure it powers on.
If the sensor
starts to overheat, disconnect
the battery immediately.
Connect the sensor in the electronic board
with the provided cable.
ELECTRONIC CONNECTIONS
Connect Transmitter, Receiver, and ESC to the Motor
Connect Sensor
Connect Sensor to Electronic Board
2
3
4
Voltage and Current Sensor Diagram Solder Connector
1
3
4
1
2
miniPRO H1 Voltage and Current Sensor Connection
Solder the connectors of your preference
OR 14 gauge wires.
6
7
5