Page 10 of 39
AN-49-005 (December 23, 2019) M176825 (R95497) File: AN-49-005(J).doc
This document and its contents are the property of Mini-Circuits
2
Chapter 2 – Installation and Setup
2.1
Software setup
System requirements for the programmable attenuator models are a computer (Pentium II
or better) with the following support depending on the control method used:
RS232 control
SPI
USB control
Ethernet control
Serial COM port
3-wire I/O control
at LVTTL
USB HID
Network connection
When using the supplied power adaptor a power source of 110-220V
AC
(with socket
matching one of the two pin plugs provided) is also needed.
To run the GUI program a Windows operating system for either 32 or 64 bits is required
as well.
No additional requirements for using units in daisy chain configuration
If you have had any problems installing the software, we’re here to help.
Try following these complete step-by-step instructions. If you still experience problems,
give us a call at Mini-Circuits Worldwide Technical support. It’s (718) 934-4500 or e-mail
[email protected] for North America or go to minicircuits.com/contact/worldwide_
tech_support.html for other regional numbers and addresses.
2.1.1
First,
save all work in progress and close any other programs that may be running.
2.1.2
Next,
download the full CD software from
https://www.minicircuits.com/softwaredownload/RUDAT_CD.zip
. Unzip the downloaded files to
a suitable folder on your computer, then open the file folder you created and double-click the
“Install” icon.
Figure 2.1.2
CD file listing window
