4
4.2 Assembly of components on the bottom of table top
- Put down antiskid (rubber) bands on the stand frame.
- Turn the table top up side down and put it down on prepared bands.
- By means of screws scerw the drawer (1)down.
- Nail down the rubber stop (2).
- By means of screws fasten transformer for lighting (3) if available.
- By means of screws fastened transformer for trimming (4) if available.
- By means of screws fasten switch circuit breaker (5).
- Screw the motor holder down (6) (possibly motor). Lever clutch motor is assembled into the holes (A). Stopmotor into holes (B).
- By means of clips (7) install transmission line of heavy current conductors. Connection is different from the type of motor,
supply voltage and number of conductors of electric supply. In case of quad (four wire) supply 3 x 400 V, transformer for
lighting must be supplied with separate supply cable 1 x 230 V.
Caution!
The voltage in the mains must be in conformity with the voltage indicated on the drive plate.
Caution!
The transformer of the bulb for the sewing area is not switched off by the main switch (EN 60204-3-1). Before
proceeding to any repair operation in the transformer box (such as a fuse exchange) the plug categorically must be
taken out of the socket. Such operations may be carried out only by persons with adequate electrotechnical skill.
Choose the suitable variant according to the pictures:
4.2.1 Power supply 1 x 230 V - DC motor
Circuit layout - Europe
Circuit layout - America
Transformer for sewing area bulb
Power for sewn work cutter
Machine
stand
Machine
head
Transformer for sewing area bulb
Power for sewn work cutter
Machine
stand
Machine
head
A
B
5
16
170
5
60
13
55
6
2
7
4
1
3
5
5
5
3
4
3
4
Summary of Contents for 4181i 3 Series
Page 38: ...13...
