Minebea Intec CAIXS2, Installation Instructions And Safety Information

Page: 7 / 136

Installationsanleitung CAIXS2 7
Getting Started
Attaching the Cable Entry
Please use extreme caution when performing any work on the equipment
that affects this cable gland.
You must use a torque wrench.
The torque for this cable gland is 5 Nm.
4 1 5
t
Remove the protective caps from the bore hole on the indicator.
t
Insert the included cable gland through the bore hole and secure from the
inside using the locknut (
1
).
t
Remove the cover plate by removing the 4 screws.
Connection terminals are now visible.
t
Before the front panel is mounted using the cover plate
and fix it.
t
Insert the cable through the cable gland until the shielding (2) comes into
contact with the clamps (3). Tighten the screw-down nut (4) until the gasket
(5) inserted between the screw-down nut and cable forms a small beaded
rim.
t
Check the shielding and clamps.
t
Securely connect the wires of the connecting cable in accordance with the
terminal assignments.
Connecting the Cable to the Analog/Digital Converter (ADC)
t
Insert all cable wires through the ferrite case, wind them around the ferrite
case and then reinsert back through the ferrite case.
t
Screw the wires tightly into the clamps.
Pin Assignment
t
Refer to the data sheet or operating instructions of the weighing platform
for details on the assignment of wire colors/signals. Ensure any lines that are
not assigned are insulated correctly.
Connect weighing platform to ADU, Option A15
1 EXC+ blue
2 Sense+ green
3 OUT+ white
4 OUT- red
5 Sense- gray
6 EXC- black
t
When connecting a load receptor that uses 4-conductor technology (the
cable of the weighing platform to be connected only has 4 lines), connect
clamp pairs 1 and 2 (EXC+ and SENSE+), and 5 and 6 (SENSE- and EXC-)
with a wire jumper.
1
2
3
4
5 6
2
3