Mine Site Technologies NS40 I.S., User Manual, Page: 48 / 98

The NS40 can have up to two MST Tracker Engines configured. The configuration parameters are
described in the table below.
Description Field
Check box to enable the MST Tracker Engine. Enabled
IP address or server name of the MST tracker engine. Server IP Address
or Name
Port number of the MST tracker engine. By default the port number
1142
. Port Number
How often status messages are sent to the MST tracker engine. Default is
15
seconds.
Status Interval
(Seconds)
Enables the reporting of detected tags to the MST Tracker engine. Send MST WIFI
Tag Reports
Enables reporting for mobile units (such as the MinePhone). Send MU Reports
Reporting factor for mobile units. By default the value is
10
, where a report is
sent for every tenth read of the device.
MU Dilution
Factor
If no frames from a mobile unit are received, the server will sent a report based
on the MU Timeout setting. By default the value is
5
seconds.
MU Timeout
The NS40 can be configured to only report tags that are within range of an AeroScout Exciter. This is
useful for gate and sign controllers.
Description Field
If enabled, the NS40 will ignore detected tags that are not also within range of an
exciter. Drop non-exciter tag
reports
Click Save to save settings or Save & Apply to instantly apply new settings.
4.5.6 Centralised Configuration Management Settings
This screen controls the NS40's centralised configuration management settings, allowing it to be configured
via TFTP (Trivial File Transfer Protocol) by the ICA or another TFTP server.
Revision C 48 NS40 I.S. Wireless Network Switch
Configuration using the Web Interface