- Install the battery
The battery should be mounted on the bottom of drone. The bottom surface of battery and the top
surface of drone are all attached with nylon fastener tape by default. Place the battery on the position of
the nylon fastener tape, and give light push on the battery to make sure it is fastened solidly. Fasten the
pre-installed nylon belt around the battery to enhance the mount.
After mounted plug the battery connect to the power head on the tail of drone.
Power On/Off
Once the battery is connected to the power head of drone, all parts will be powered on. The main LED on
flight controller will turn to breathing blue and the drone is now ready for command.
Disconnect the battery when you finished a flight.
Charging battery
Battery can be charged through the built-in USB charger. Connect the USB port (type C) to any standard
5V output power source (like computer USB ports, power bank, etc.) and the charging will start. The
orange LED indicator is constantly on during charging. After charging is completed, the orange LED will
be out and the green LED will be on.
The power supply to flight controller and other components on the frame will be cut off once the
charging port is connected to valid power source.
Fig. 4 USB charger
Note
Be careful not to mix the charger USB port with the USB port on flight controller. Charger USB port
is on the bottom plane of the frame (as in Fig. 4).
Page 6
USB charger port
