Page 13
Adjusting Intensity
Note: The intensity button (INT) is raised to guide you in locating button
with eyes closed during sessions
. To increase the intensity of the lights in
the Omniscreen eyeset, press and hold the INT button. To decrease the
intensity, release the INT button and press and hold again. Or you may
press short single steps for small adjustments in the intensity. The
indicator lights 1 to 6 will show the intensity level.
To Save Intensity, Volume, Tone and Heartbeat Settings
Specific preferences (settings of intensity, volume, tone and heartbeat on
or off) can be saved for each session. To save preferences, while the
session is running, adjust intensity, volume, tone and heartbeat as desired.
Press and hold SEL and INT. The indicator lights 1 to 6 will scroll from 1
to 6 and back to 1. Your new preferences will be saved only when the
session ends (until all lights and tones are completely off). You may use
Soft Off
TM
(press and hold INT and VOL) to end the session sooner (2
minutes).
Playing Pre-Recorded Material
To play pre-recorded material into the headphones, plug one end of the
patch cord provided into the headphone jack of the CD, MP3, computer
or cassette tape player and plug the other end into the AUDIO IN jack of
the DAVID PAL36 with CES. If the playing time of the audio material is
longer than the session selected, the session will end, but the audio
material will continue to play and be heard through the headphones.
Playing Sound Sync (LIB2 – B3 – B6)
Using the patch cord provided, connect your CD, MP3, computer or tape
player to the DAVID PAL36 with CES (follow instructions above).
Select Sound Sync session. With the Omniscreen eyeset on, increase the
volume on the audio material until you notice the lights "dance". If there
is no sound for 30 seconds, the Omniscreen eyeset lights will Soft Off
TM
.
When the sound returns, the lights will brighten up and "dance" again.
Battery Replacement and Power Management
The PAL36 with CES can be powered using a 9-volt battery or a 9-volt
adapter (positive centre, 1.3 mm plug). If the PAL36 with CES is plugged
into an adapter, no power will be used from the battery. For safety
reasons, the CES section will not operate if the PAL36 with CES is
plugged into an adapter. To turn CES on, reset the CES intensity slider to
off position (far left). If the CES slider is not reset, the CES power light
Summary of Contents for DAVID PAL36
Page 23: ...Page 23 DAVID PAL36 with CES...
