Minarik PCM21000A, User Manual

Page: 49 / 52

43
If the end-user is using a CE-approved motor, the correct filter
from Table 3 is all that is necessary to meet the EMC directives
listed herein.
If the end-user is not using a CE-approved motor, a second
filter, Minarik p/n CEXXMM, on the output must be deployed.
XX = rated current of the filter.
The CE20MM is a Real-Pole Balanced-Pi 3-pole filter. If the
exact filter is not available, the specifications are as follows:
L & L1 = 2 * (0.8) milliHenries.
C & C1 = 2 * (0.1) microFarads @ 400W VDC.
Rin = 0.1 ohm; Rout = 1.2 ohm.
Table 4. Minarik® Filters
Nameplate Current of Minarik® Filter
Motor Wired to the Drive Part Number
0 to 4 amps CE4MM
4.1 to 13 amps CE20MM
The filters in Table 4 must be wired to the DC
output of the drive, as close to the drive as possible.
The ground connection from the filter must be wired
to solid earth ground (resistance less than 500
ohms); not machine ground. This is very important!
Certificate of Compliance
250-0090-rev5.qxd 3/9/01 10:25 AM Page 43