15
MIMLED 600 / MIMLED 1000
CAUTION – DAMAGE TO THE DEVICE
After the installation of the end device, perform tilt test according to DIN EN
60601-1.
Use the same procedure with ceiling and wall mounting regarding installation
and dismantling.
DISMANTLING AND REASSEMBLY FOR SERVICING
INSTALL END DEVICE ON THE MOBILE STAND
2. Remove protective cap from the spring arm opening.
WARNING – DANGER OF INJURY
The spring arm which is pressed downwards can snap back up and cause injury.
During the installation of the end device, no people should be located within the
swivel range of the spring arm.
3. Push the plastic sleeve on the arm so that the two slots are covered.
4. Insert the terminal‘s swivel arm end (remove protective grease cover before).
5. Insert the locking segment completely into the slot so that the locking segment
is guided into the groove.
6. Rotate plastic sleeve by 180° and tighten the screw.
7. Check secure seating of the end device.
Locking segment
