6
3
Wipe off the ink sticking to the cap absorber
with a clean stick or nonwoven towel dipped
in cleaning solution.
• Soak the clean stick or the nonwoven towel in the
maintenance cleaning liquid and wipe off an
accumulated ink.Wipe off so that cleaning solution for
maintenance will not remain.
If the cap absorber is very dirty, replace the cap absorber
with the new one (SPA-0269) in accordance with "Replacing
the Cap Absorber" on Chapter 4 of the Operation Manual.
(3) Wiper ("Cleaning the Wiper and Cap” Chapter 4 of the Operation Manual)
On the wiper, the ink, dust and paper powder are liable to accumulate. Check the state of the wiper and if it is
stained, clean it. When cleaning the twin wiper, follow the procedure below.
• Use the cleaning liquid dedicated for the ink being used.
1
Move the carriage and open the right
maintenance cover.
• Refer to the Step 1 to 2 of Chapter 4 “Cleaning the
Wiper and Cap” of the user’s manual to perform the
operation.
2
Clean the wiper.
• Remove the wiper by holding the protrusions at its
both ends.
• Wipe off the ink sticking to the wiper and bracket with
a clean stick dipped in cleaning solution for
maintenance. Wipe off so that cleaning solution for
maintenance will not remain.
3
Clean the wiper cleaner.
• Wipe off the ink sticking to the wiper cleaner with a
clean stick dipped in cleaning solution for maintenance.
Wipe off so that cleaning solution for maintenance will
not remain.
• For the twin wiper
Cap Absorber
Carriage
Wiper
Projection
Bracket
Projection
Wiper
Bracket
Wiper cleaner