5
Cleaning of the media sensor at the rear surface
of the equipment
Platen ("Cleaning the platen" Chapter 4 of the Operation Manual)
Platen is a place where dusts, paper powder, and ink are liable to accumulate. It is therefore suggested to clean
it frequently. Wipe out the platen surface and the platen cover with a soft blush or cloth. The grooves for media
holder and for cutting the paper (cutter line) are the place where the dusts are especially liable to accumulate.
Clean them thoroughly.
Exterior ("Cleaning exterior surfaces" Chapter 4 of the Operation Manual)
Depending on the using environment, the dusts or sand powder could stick to the exterior of the main unit. To
avoid the entry of the dusts into the moving part of the head, wipe them off with soft cloth dipped into water and
squeezed tightly
Waste ink tank ("If Waste ink tank confirming message is displayed" Chapter 4 of the
Operation Manual)
Check whether the waste ink tank is full or not. Take care so that the waste ink never overflows the tank.
Media
sensor
