1
Inkjet Printer TS30-1300
Requests for Care and Maintenance
Inkjet printer is a precision machine equipped with extremely fine mechanisms. Especially, the nozzle surface of the
heads from which the ink is discharged is affected even by a slightest attachment of dust or paper powder and the
proper drawing results could not be obtained. With a view to using this inkjet printer in a better condition, we would
like to recommend performing the following care and maintenance on daily basis.
Use this printer as much as possible in a dust-free environment. Fans and air-blowers could cause the dust-
spewing.
When solvent inks are to be used, install the printer in a well-ventilated space.
The using environment of this printer is from 20 to 35
o
C in temperature and from 35 to 65 % in relative
humidity. Avoid the use of this printer at a temperature and humidity higher or lower than the indicated
ranges.
CAUTION
When TS30 printer is used filling solvent ink, make sure to wear the attached
goggles and gloves
.
The solvent ink, if mixed with water or alcohol, generates condensed substances. Pay attention not to
deposit water or alcohol to the nozzle surface, surrounding area of the heads, caps and wipers.
To secure the stability of the ink discharge, when the printer is not used (output) for an extended
period of time, it could become necessary to discharge periodically a small amount of ink (flushing),
depending on the kinds of the ink.
When not using for an extended period of time, execute the [CUSTODY WASH] function of this equip-
ment, ("In case of no use for long term" Chapter 4 of Operation Manual) and put off the power switch
on the front, only. Leave the main power switch at the side of the equipment on and keep the cable
socket inserted into the plug.
Never disassemble this equipment. It could cause electrical shock, fire and breakage.
Keep away the moisture from the inside of this equipment. If the inside is moistened, it could cause
electrical shock, fire and breakage.
Perform the maintenance and care after switching off the power and taking off the power cable. Other-
wise, it could cause unexpected accidents.
Avoid using benzene, thinner, and chemicals containing abrasive compounds. The surface of the
cover could be degenerated or deformed.
Do not supply lubricant oil etc. to the inside this equipment.
It could cause the break of the printing mechanisms.
1. Installation environment
