- 4.5 -
Setup functions
The following describes the overview of and settings for each function.
MEDIACOMP.
When the medium type or heater temperature is changed, be sure to correct the amount of feed
according to the medium thickness.
P.2-32
(-255-255)
HEATER
(Temperature setting during plotting
P.2-28 )
Sets the printer heater and preheater built in the platen.
PRE HEAT :
Sets the temperature of the preheater.
(OFF, 20- 60
o
C / 68- 140
o
F)
PRINT HEAT :
Sets the temperature of the printheater.
(OFF, 20- 60
o
C / 68- 140
o
F)
o
C /
o
F :
Selects the unit of temperature.
(
o
C /
o
F )
STANDBY :
Sets the time interval since when plotting is completed till when the heater temperature
begins to drop to the preheat temperature. The preheat temperature is preset and cannot
be changed. When receiving the data under low temperature condition, it raises the
temperature up to the set value automatically before execute plotting.
When [NONE] is selected, the temperature does not drop to the preheat temperature.
(NONE, 10- 90 min /10min step)
OFF TIME :
When receiving the data under setting the heater to OFF, it raises the temperature up to
the set value automatically before execute plotting.
With [NONE] selected, the heater is not turned off.
(NONE, 30, 60, 90 min.)
Downloaded From ManualsPrinter.com Manuals
Summary of Contents for JV3-250 SP
