- 4.14 -
Establishing An Origin
Establish an origin in terms of data on media loaded on the device.
In the case of printing with the unspecified origin, set the origin again.
STEP
1.
After the medium detection is completed, move
the carriage to the position at which to estab-
lish an origin by pushing the JOG keys [ ], [ ],
[ ] and [ ].
2.
After deciding the origin, push the [ENTER]
key.
The effective plotting area is displayed on the LCD, and the
device enters the LOCAL mode.
(When a roll medium is used, X is not detected.)
When the device stars plotting the next time, it uses the
origin that has been established unless the origin is changed.
Standard of printing origin
The printing origin in set like right chart when shipping.
The value of scanning direction (X’) can be changed with
[Margin] in FUNCTION mode.
<LOCAL>
Width : 2475 mm
ORIGIN SET UP
0. 0
0. 0
ORIGIN
X = 1500 mm
Y = 972 mm
Origin(Length)
Origin(Width)
15 mm
(Y’)
Cutting line
15 mm
(X’)
Downloaded From ManualsPrinter.com Manuals
Summary of Contents for JV3-250 SP
