© 2009 MIMAKI ENGINEERING CO.,LTD.
6.3.1
P.1
R.1.0
Maintenance Manual > Disassembly and Reassembly > Cut Head Carriage > Pen Assy and LED Pointer
Model CJV30/TPC Issued 2008.08.04 Revised
F/W ver. 1.00 Remark
1.0
6.3.1 Pen Assy and LED Pointer
Work procedures
1. Remove the following covers.
•
C Head cover
•
CY cover F
2. Move the cutting carriage on the platen.
3. Remove the
S-guide
, and then the
auto cutter assy
.
4. Remove screws from the rear and the front of the printer to take
off the
pen assy
.
5. Remove the connector from PCB and also
LED pointer
from
the pen assy.
6. Reverse the disassembly procedure for reassembly.
Pen Assy
LED Pointer
S Guide
Auto Cutter Assy
Take care not to change the orientation of the hook of
the whirl-stop SP.
Changing the orientation will change the pen
pressure and the pen landing values.
Pen Assy
LED Pointer
