![background image](http://html.mh-extra.com/html/milwaukee/mxf-tl/mxf-tl_user-manual_1798804018.webp)
18
English
18
The LED of the charger changes from red to green when it is
fully charged.
Remove the battery pack from the product for charging for
convenience. MILWAUKEE batteries do not develop a memory
when charged after only a partial discharge. It is not necessary
to run down the battery pack before placing it on the charger.
As a general practice, it is best to unplug battery chargers and
remove batteries when not in use. No battery pack damage
occurs unless the charger and battery pack are left plugged in.
The charger keeps the battery pack fully charged if it is left on
the charger. The light indicator is the same as normal charging.
If the light indicator
fl
ashes red and green, check that the
battery pack is fully seated into the bay. Remove the battery
pack and reinsert. If the light continues to
fl
ash red and green,
remove the battery pack(s) and unplug the charger for at least
2 minutes. After 2 minutes, plug the charger back in and insert
the pack. If the problem persists, contact a MILWAUKEE
service centre.
LIGHT INDICATORS
Continuous red
Charging
Slow
fl
ashing
green
Approaching full charge
Continuous green
Charging is complete
Fast
fl
ashing red
Battery or charger is too
hot/cold. Charging begins
when the battery or charger
reaches the correct charging
temperature.
Flashing red /
green
Damaged or faulty battery
pack or charger
BATTERIES
Battery packs that have not been used for some time should be
recharged before use.
Temperatures in excess of 50°C reduce the performance of
the battery pack. Avoid extended exposure to heat or sunshine
(risk of overheating).
The contacts of the chargers and battery packs must be kept
clean.
For an optimum life-time, the battery packs have to be fully
charged after use.
To obtain the longest possible battery life remove the battery
pack from the charger once it is fully charged.
For battery pack storage longer than 30 days:
●
Store the battery pack where the temperature is below
27°C and away from moisture.
●
Store the battery packs in a 30% - 50% charged condition.
●
Every six months of storage, charge the pack as normal.
BATTERY PACK PROTECTION
The battery pack has an overload protection that protects it
from being overloaded and helps to ensure a long life.
Under extreme stress, the battery electronics automatically
turns o
ff
the product. To restart, turn o
ff
the product and then
turn it on again. If the product does not start up again, the
battery pack may have discharged completely. In this case the
battery pack must be recharged in the battery charger.
TRANSPORTING LITHIUM BATTERIES
Lithium-ion batteries are subject to the Dangerous Goods
Legislation requirements.
Transportation of those batteries has to be done in accordance
with local, national and international provisions and regulations.
●
Batteries can be transported by road without further
requirements.
●
Commercial transport of Lithium-Ion batteries by third
parties is subject to Dangerous Goods Regulations.
Transport preparation and transport are exclusively to
be carried out by appropriately trained persons and the
process has to be accompanied by corresponding experts.
When transporting batteries:
●
Ensure that battery contact terminals are protected and
insulated to prevent short circuit.
●
Ensure that battery pack is secured against movement
within the packaging.
●
Do not transport batteries that are cracked or leaking.
Check with forwarding company for further advice.
MAINTENANCE
The light source of this luminaire is not replaceable; when the
light source reaches its end of life the whole luminaire should
be replaced.
Use only MILWAUKEE accessories and spare parts. Should
components that have not been described need to be replaced,
contact one of our MILWAUKEE service centres (see our list of
guarantee or service addresses).
If needed, an exploded view of the product can be ordered.
State the product type and the serial number on the label, and
order the drawing at your local service centre.
SYMBOLS
CAUTION! WARNING! DANGER!
Remove the battery pack before starting any
work on the product.
Always disconnect the plug from the socket
before carrying out any work on the product.
CAUTION! Possibly hazardous optical radiation
are emitted from the product. Do not stare at the
operating lamp. It may be harmful to the eye.
Summary of Contents for MXF TL
