5
Maintaining Tool
Keep your tool, battery pack and charger in good repair
by adopting a regular maintenance program.
After six months to one year, depending on use, return
the tool, battery pack and charger to the store where
the product was originally purchased or one of our
authorised MILWAUKEE® FORCELOGIC™ service
centres for:
• Lubrication
• Mechanical inspection and cleaning (gears, spindles,
bearings, housing, etc.)
• Electrical inspection (battery pack, charger, motor)
• Testing to assure proper mechanical and electrical
operation
If the tool does not start or operate at full power with a
fully charged battery pack, clean the contacts on the
battery pack. If the tool still does not work properly,
return the tool, charger and battery pack, to the store
where the product was originally purchased or one
of our authorised MILWAUKEE® FORCELOGIC™
service centres.
MAINTENANCE
WARNING
To reduce the risk of injury,
always unplug the charger and remove the
battery pack from the charger or tool before
performing any maintenance. Never disas-
semble the tool, battery pack or charger.
Contact a MILWAUKEE® service facility for
ALL repairs.
ACCESSORIES
CUSTOMER SERVICE
For a complete listing of accessories refer to your
MILWAUKEE® accessories catalogue or go online to
milwaukeetools.com.au or milwaukeetools.co.nz. To
obtain a catalogue, contact the store where the product
was originally purchased or one of our authorised
MILWAUKEE® FORCELOGIC™ service centres.
WARNING
Always remove battery pack
before changing or removing accessories.
Only use accessories specifically recommend-
ed for this tool. Others may be hazardous.
Cleaning
Clean dust and debris from charger and tool vents.
Keep tool handles clean, dry and free of oil or grease.
Use only mild soap and a damp cloth to clean the
tool, battery pack and charger since certain cleaning
agents and solvents are harmful to plastics and other
insulated parts. Some of these include gasoline,
turpentine, lacquer thinner, paint thinner, chlorinated
cleaning solvents, ammonia and household detergents
containing ammonia. Never use flammable or
combustible solvents around tools.
Repairs
For repairs, return the tool, jaws, rings, battery
pack and charger to the store where the product
was originally purchased or one of our authorised
MILWAUKEE® FORCELOGIC™ service centres.
WARNING
To reduce the risk of per
sonal injury and damage, never immerse your
tool, battery pack or charger in liquid or allow
a liquid to flow inside them.
Troubleshooting
LED
Cause
Solution
Green LED
flashing
The battery is not sufficiently charged
to complete a pressing operation.
Charge the battery.
The retaining pin is not correctly shut
or has come loose.
Insert the retaining pin, or check the
retaining pin and cylinder.
NOTE: the pressing operation may
not have been completed. Check and
repeat if necessary.
Red LED
flashing
Device not within operating
temperature range.
Bring device into operating
temperature range (-10°C to 50°C)
Red LED on
Device fault
Retry operation. If Red LED remains
lit, return the tool, charger and battery
pack, to a
MILWAUKEE®
service
facility for repairs.
Green and Red
LED flashing
alternately
Service needed
Return the tool, charger and battery
pack, to a
MILWAUKEE®
service
facility for maintenance.
Australia:
1300 MILWAUKEE (1300 645 928)
www.milwaukeetools.com.au
New Zealand:
0800 279 624
www.milwaukeetools.co.nz
