FIRST START
01.
Connect the milquino® to the power supply. Die Main Button is illuminated red.
02.
Clean the Water and Powder Container and their parts with lukewarm Water.
NOTE
:
Water- und Powdercontainer and their parts are suitable for dishwasher use, but not over 60°C.
Do not use
Vapour Sterilizer for cleaning!
03
. Fill up Water Container and put it to the backside of the device in proper position.
NOTE
: It is prohibited to use tea inside instead fo water.
04.
Install the Powder Container with its parts, but do not fill up powder at this point.
05.
Switch on the device by pressing button
Ready for operation:
Main Button
is illuminated green.
06.
Put any suitable jar below the Water outlet and press button
for rinsing the water system.
Repeat 3 times. While now you have the possibility to check the dispensed water amount and correct if neccessary.
Use description on page 08.
NOTE: Until the complete deairation of the water pump system the noice emmission could be higher for short
period of time.
07.
Now the powder container is ready for filling. The dosing system has to be covered with powder completely for
constant powder dispensing.
NOTE: Ensure the powder container and all parts inside remain totally dry before filling up Powder. Wet Powder
will block the dosing system!
Heavy rubbing of the powder tank with a tea towel can charge the powder tank with
static electricity. As a result, fine powder dust adheres to the tank. Occasionally remove this with a dry cloth.
08.
Your milquino® is ready for usage.
05
Summary of Contents for Black & White
Page 2: ...Notes...
Page 19: ...NOTES...
