Milnor 48040F7B, Manual, Page: 49 / 137

Chapter 3. Routine Maintenance
PELLERIN MILNOR CORPORATION
Figure 24: Example of Disk Brake. Your machine can look different.
Views of Brake Assembly and Reservoir
Legend
1. Correct fluid level. You can add fluid to this level when the brake is applied or not applied.
.
3.1.7.
Maintenance Components—Hydraulic Power Group
[Document
BIPPBM05]
Figure 25: Hydraulic Power Components and System Oil Capacity
Hydraulic Power Assembly Legend
.
1. Breather. Add oil here. Tank capacity =
15.5 gallons (59 liters). Approximate
system capacity = 17 gallons (64 liters).
You cannot fully remove all oil from the
system in routine maintenance.
2. Remove oil here.
3. Level and temperature gauges
4. Tank is full when the level is here.
5. Housing with oil filter
6. Hydraulic pressure gauge
Supplement 6
How to Replace the Hydraulic Oil or Add Oil to the Full Mark
If the drain and/or the fill pipe on the tank has a quick disconnect fitting, remove it if necessary
to connect a hose. After you complete the work, put the fitting or a cap on the pipe.
To remove the used oil—
1. Make sure the valve on the drain pipe is closed.
2. Install the hose between the drain pipe and the container you will use to collect the used oil.
Remove the quick disconnect fitting from the drain pipe if necessary.
3. Operate the manual valve to let the oil flow. Close the valve when the tank is empty.
45