Torque Requirements for Fasteners
PELLERIN MILNOR CORPORATION
Apply the threadlocker only to the areas where the fastener threads and the mating threads
engage.
Figure 2: Blind Hole
Application
Coverage
Legend
A.
No threadlocker here
B.
Apply here
C.
Fill all space with threadlocker
.
3.1.
Blind Holes
1. Apply the threadlocker down the threads to the bottom of the hole.
2. Apply the threadlocker to the bolt.
3. Tighten the bolt to the value shown in the correct table (
to
3.2.
Through Holes
1. Put the bolt through the assembly.
2. Apply the threadlocker only to the bolt thread area that will engage the nut.
3. Tighten the bolt to the value shown in the correct table (
to
Figure 3: Through Hole
Application
Legend
A.
No threadlocker here
B.
Apply the threadlocker to this area
x.
Nut depth
.
3.3.
Disassembly
—For high-strength threadlocker, apply heat for five minutes. Disassemble with
hand tools while the parts are hot.
For low-strength and moderate-strength threadlocker, disassemble with hand tools.
34
Summary of Contents for 30015T6X
