OM-262379 Page 23
SECTION 7 − MAINTENANCE & TROUBLESHOOTING
7-1.
Routine Maintenance
Maintain more often during
severe conditions.
!
Disconnect power
before maintaining.
= Check
= Change
= Clean
= Replace
Every
3
Months
Replace
Damaged
Or
Unreadable
Labels
Replace
Damaged Gas
Hose
Repair Or Replace
Cracked Cables And
Cords
Every
6
Months
Clean
Drive
Rolls
Blow Out Or
Vacuum Inside
7-2.
Overload Protection And Thermostat Protection
Ref. 265 368-B
!
Turn Off wire feeder and
welding power source. Stop
engine on welding
generator.
1
Supplementary Protector CB1
CB1 protects wire feeder from over-
load. Correct problem and reset
CB1.
Close and latch door.
Thermostat Protection
Unit has internal thermostat protec-
tion and will not feed wire if over-
heating occurs (see Section 7-4).
CB1
1
Internal Side View
