A complete Parts List is available at www.MillerWelds.com
OM-279299 Page 27
5-16. Threading Welding Wire For XR-Aluma-Pro Or XR-Aluma-Pro Lite
1
Wire Spool
2
Welding Wire
3
Inlet Wire Guide
4
Drive Roll
5
Outlet Wire Guide
6
Pressure Adjustment Knob
7
Gun Conduit Cable
Lay gun cable out straight.
Tools Needed:
6 in.
(150 mm)
Hold wire tightly to keep
it from unraveling.
Open pressure assembly.
Pull and hold wire;
cut off end.
Push wire thru guides into gun;
continue to hold wire.
Close and tighten pressure
assembly, and let go of wire.
See Section 5-17 for threading
welding wire through XR guns.
282952-A / S-0627-A
Tighten
1
2
3
4
Pressure
Indicator
Scale
6
7
3
5
2
1
4
Thread hub tension
nut loosely
.
Use pressure indicator scale to
set a desired drive roll pres-
sure. Begin with a setting of 2.
If necessary, make additional
adjustments after trying this ini-
tial setting.
Summary of Contents for Millermatic 255
