Miller 907439002, Owner'S Manual

Page: 29 / 90

General
OM-249474 Page 23
Ref. 245 741-C
1 Ethernet Receptacle Port A
2 Ethernet Receptacle Port B
Port A and Port B are identified by the IP
address from the network server.
Ethernet receptacles provide
connections for either a network cable
or a laptop PC or both.
3
Optional MWCI Receptacle
4 Optional WFS (Wire Feed Sensor)
5 Optional GFS (Gas Flow Sensor)
Receptacle
6 Optional DeviceNet Receptacle
DeviceNet option provides hardware
and software that allows the welding
power source to be connected into a
DeviceNet network. Contact factory for
option details.
7-4. Upper Rear Panel Receptacles
1
3
6
2
4 5
Ref. 245 741-C
1 115 V 10 A AC Receptacle RC2
Receptacle supplies 60 Hz
single-phase power. Maximum output
from RC2 is limited by supplementary
protector CB1 to 10 amps.
2
Supplementary Protector CB1
3 Supplementary Protector CB2
CB1 protects 115 volt receptacle RC2
from overload. If CB1 opens, RC2 does
not work.
CB2 protects the wirefeed motor from
overload. If CB2 opens, the wirefeeder
does not work.
.
Press button to reset breaker. If
breaker continue to open, contact a
Factory Authorized Service Agent.
4 Network Wire Feeder Receptacle
RC1
Use receptacle to connect network
feeder cable to power source (see
Section 7-2).
5
Optional E-Stop Receptacle RC4
7-5. Lower Rear Panel Receptacles And Supplementary Protectors
2
3
1
4
5