Miller 907186, Owner'S Manual

Page: 32 / 80

Complete Parts List available at www.MillerWelds.com Complete Parts List available at www.MillerWelds.com
OM-4421 Page 26
5-4. Installing Exhaust Pipe
1/2 in.
Tools Needed:
Exhaust1 2008 − 01 Ref. 803 604 / Ref. 236 972
!
Stop engine and let cool.
Point exhaust pipe in desired di-
rection but always away from front
panel and direction of travel.
NOTICE − Lead acid batteries discharge
when stored in any temperature. Units that
are stored should have the battery
recharged every three months and before
being put into service. To preserve opti-
mum battery performance and life,
recharge battery in storage when the
open − circuit voltage drops to 12.4 volts
DC when measured across the battery
terminals.
!
Connect negative ( − ) cable last.
NOTICE − Wait two minutes after engine
shutdown before disconnecting battery or
engine controller may be damaged.
Battery is most easily accessed through
the rear panel. Remove battery access
panel from rear panel. Connect battery,
negative cable last. Reinstall battery ac-
cess panel.
Do not allow the battery cables to
touch opposing terminals. When con-
necting the battery cables attach the
positive (+) cable to the positive (+)
battery terminal first, followed by neg-
ative ( − ) cable to negative ( − ) battery
terminal.
Never start the engine when the ca-
bles are loose or poorly connected to
the battery terminals.
Never disconnect the battery while
the engine is running.
Never use a quick battery charger to
start the engine.
Do not charge battery with Engine
Control switch On.
Always disconnect the negative ( − )
battery cable before charging battery.
5-5. Connecting The Battery
1/2 in.
−
+
Tools Needed:
Conn_batt1 2014 − 06 802 168-E / S-0756-C