Miller Electric M-10 Gun, Owner'S Manual

Page: 17 / 52

OM-1328 Page 13
SECTION 4 − INSTALLATION
4-1. Installing Work Clamp
1 Insulating Sleeves
2 Nut
3 Work Cable From Unit
Slide one insulating sleeve over
work cable before connecting to
clamp.
4 Work Clamp
5 Screw
6 Work Clamp Tabs
Bend tabs around work cable.
Slide insulating sleeves over
handles.
802 456-A
Tools Needed:
3/8, 7/16 in
1
2
3
4
5
6
4-2. Connecting Welding Gun
Ref. 803 810-D
1 Gun Securing Knob
2 Gun Block
3 Gun Outlet Wire Guide
Loosen knob, insert gun end into block. Po-
sition outlet wire guide as close as possible
to drive rolls without touching. Tighten
knob.
4 Gun Trigger Plug
5 Gun Trigger Receptacle
Connect trigger plug to receptacle. Be sure
not to pinch lead when closing case.
6
Positive Weld Terminal
7 Negative Weld Terminal
8 Work Cable w/Boot
Connect work cable to either the positive or
negative weld terminal, depending on the
wire type (see Sections 4-3 and 4-4). The
illustration shows electrode positive
(DCEP) for gas-shielded wires.
9 Work Clamp
Connect work clamp to workpiece.
3
9
1
2
4
5
6 7
8
) *