Miller Electric ICE-100T, Owner'S Manual

Page: 35 / 56

.
A complete Parts List is available at www.MillerWelds.com
OM-201 872 Page 31
80 Amp Machine Torch Shielded Consumables
The following cut charts are based on a distance of 1/16 in (1.6 mm) between torch and workpiece for all cuts.
212 733 212 732 212 734 212 724 212 726
Swirl Ring Electrode Tip Retaining Cap Shield
ICE-100TM Torch
Sense Tab*
226 763
*Shield sense tab 226 763 provides feedback to a compatible torch height controller before starting the cutting process.
.
Shield sense tab is located in the consumable storage box on left side of unit wrapper.
Mild Steel
Arc Current Arc Voltage
Pierce
Delay
Material Thickness Maximum Cut Speeds Optimum Cut Speeds
Arc Current Arc Voltage
Pierce
Delay
Inches mm IPM mm/min IPM mm/min
133 0.25 3/16 4.8 216 5,486 140 3,556
134 0.5 1/4 6.4 161 4,089 105 2,667
137 0.5 3/8 9.5 94 2,388 61 1,549
80
141 0.5 1/2 12.7 60 1,524 39 991
80
145 1.0 5/8 15.9 40 1,016 26 660
148 N/A 3/4 19.0 31 787 20 508
150 N/A 7/8 22.2 23 584 15 381
156 N/A 1 25.4 16 406 10 254
Stainless
Arc Current Arc Voltage
Pierce
Delay
Material Thickness Maximum Cut Speeds Optimum Cut Speeds
Arc Current Arc Voltage
Pierce
Delay
Inches mm IPM mm/min IPM mm/min
134 0.25 3/16 4.8 216 5,486 140 3,556
136 0.5 1/4 6.4 158 4,013 103 2,616
140 0.75 3/8 9.5 83 2,108 54 1,372
80
142 0.75 1/2 12.7 50 1,270 33 838
80
145 N/A 5/8 15.9 34 864 22 559
150 N/A 3/4 19.0 24 610 16 406
153 N/A 1 25.4 14 356 9 229
Aluminum
Arc Current Arc Voltage
Pierce
Delay
Material Thickness Maximum Cut Speeds Optimum Cut Speeds
Arc Current Arc Voltage
Pierce
Delay
Inches mm IPM mm/min IPM mm/min
134 0.25 1/8 3.2 454 11,532 295 7,493
139 0.25 1/4 6.4 176 4,470 114 2,896
80
144 0.75 3/8 9.5 121 3,073 60 1,524
80
146 0.75 1/2 12.7 75 1,905 37 940
154 N/A 3/4 19.0 37 940 19 483
Without concern for cut appearance, the fastest speed for cutting material is the maximum cut speed. For better cut angle, less dross, and cut surface
appearance, use the optimum cut speed. The values in the cut charts are basic starting points and each application may require some adjustment to
achieve the best cut characteristics.