OM-4409 Page 28
5-8. Connecting To Weld Output Terminals
803 231 / 803 778-A
Tools Needed:
3/4 in
MIG And FCAW Welding
For MIG welding Direct Current Electrode
Positive (DCEP), connect wire feeder
cable to Positive (+) terminal on left and
work cable to Negative (
−
) terminal on
right. Use Process/Contactor switch to
select type of weld output (see Section
6-3).
For MIG and FCAW Direct Current Elec-
trode Negative (DCEN), connect wire
feeder cable to Negative (
−
) terminal on
right and work cable to Positive (+) termi-
nal on left. Use Process/Contactor switch
to select type of weld output (see Section
6-3).
If equipped with optional Polarity/AC Se-
lector switch, connect wire feeder cable to
Electrode terminal on left and work cable
to Work terminal on right.
2
1
Stick And TIG Welding
For Stick welding Direct Current Electrode
Positive (DCEP), connect electrode hold-
er cable to Positive (+) terminal on left and
work cable to Negative (
−
) terminal on
right.
For Stick and TIG Direct Current Elec-
trode Negative (DCEN), connect elec-
trode holder cable to Negative (
−
) terminal
on right and work cable to Positive (+) ter-
minal on left.
If equipped with optional Polarity/AC Se-
lector switch, connect electrode holder
cable to Electrode terminal on left and
work cable to Work terminal on right.
6
4
5
Do not place
anything between
Correct Installation
Incorrect Installation
3
weld cable terminal
and copper bar.
!
Stop engine.
1
Positive (+) Weld Output Terminal
2
Negative (
−
) Weld Output Terminal
!
Failure to properly connect weld
cables may cause excessive heat and
start a fire, or damage your machine.
3
Weld Output Terminal
4
Supplied Weld Output Terminal Nut
5
Weld Cable Terminal
6
Copper Bar
Remove supplied nut from weld output termi-
nal. Slide weld cable terminal onto weld output
terminal and secure with nut so that weld cable
terminal is tight against copper bar.
Do not
place anything between weld cable termi-
nal and copper bar. Make sure that the sur-
faces of the weld cable terminal and cop-
per bar are clean.
Summary of Contents for Big Blue Air Pak
Page 25: ...OM 4409 Page 21 4 13 Manufacturing Rating Label...
Page 47: ...OM 4409 Page 43 SECTION 9 ENGINE GENERATOR MAINTENANCE 9 1 Engine Maintenance Label...
Page 66: ...OM 4409 Page 62 SECTION 13 CIRCUIT DIAGRAM Figure 13 1 Circuit Diagram For Welding Generator...
Page 67: ...OM 4409 Page 63 221 915 C...
