1.
Unfold the feet of the tripod until the cross braces are in a horizontal position.
2.
Fix this position with the safety screw on the slider to which the three feet are attached.
3.
Loosen the two safety screws on the crossbar mounting at the upper end of the stand,
attach the crossbar and tighten it with the two safety screws on the mounting.
4.
Pull out the two safety bolts and loosen the two safety screws on the extension tubes.
5.
Pull out the upper extension tube to the desired height, insert the safety pin through the
appropriate grid holes and slide the safety cotter through the hole in the safety bolt.
6.
Fix the position of the upper extension tube with the safety screw on the upper tube
clamp.
7.
Pull out the lower extension tube to the desired height, insert the safety pin through the
appropriate grid holes and slide the safety cotter through the hole in the safety bolt.
8.
Fix the position of the lower extension tube with the safety screw on the lower tube
clamp.
9.
Tighten the Allen screws on the upper and lower tube clamps with the supplied Allen
key.
Setting up
Operating
LST-310
13
