Installation Instructions
FCAV1U
7
Installing to a Concrete Wall
1.
Determine the center of the TV screen, and where it should
be located on the wall.
2.
Line up the notches on accessory (A) with center of screen
marking to determine vertical center. (See Figure 1)
3.
Measure up 8" (203.2mm) from the center point to mark
location of the upper mounting slots. (See Figure 1)
4.
Using a level, mark the wall through both upper mounting
slots. (See Figure 3)
Figure 3
CAUTION:
MINIMUM HORIZONTAL DISTANCE
BETWEEN WALL BRACKETS IS 16" (406.4mm). Do not
place FCAV1U pullout accessories closer together than 16"
(406.4mm).
5.
Drill one 3/8" x 3-1/2" (9.5mm x 88.9mm) pilot hole at each
marking.
6.
Install an anchor (C) into each pilot hole using a hammer,
making sure that the anchor is flush with the wall.
NOTE:
The slotted washers have been included to help make
the installation easier. Wait to place the slotted washer
AFTER
the Fusion pullouts are hanging on the partially
installed lag bolts. (See Steps 7-10)
7.
Partially install two 5/16 x 2-1/2" flanged lag bolts (B) into
pilot holes but do not tighten to wall.
8.
Hang accessory (A), aligning upper mounting slots over lag
bolts, and adjust side-to-side for proper location.
9.
Place one slotted washer (D) over each flanged lag bolt.
(See Figure 3)
10. Tighten lag bolts to secure accessory (A) to wall at upper
mounting slots.
11. Mark the attachment points for the lower mounting slots,
making sure the attachment points are located on the studs.
(See Figure 3)
12. Drill 3/8" x 3-1/2" (9.5mm x 88.9mm) pilot holes at markings
for lower mounting holes. (See Figure 3)
13. Use two 5/16 x 2-1/2" flanged lag bolts (B) and two 5/16"
slotted washers (D) to attach the accessory to the wall
through the lower mounting holes. (See Figure 3)
ATTACHING MOUNTING SYSTEM
1.
Attach top of mounting system (not included) to top of
FCAV1U accessories using two 5/16-18 x 1/2" button head
cap screws (G) and two 5/16" washers (J) in each top
mounting slot. (See Figure 4)
2.
Attach bottom of mounting system to bottom of FCAV1U
accessories using two 1/4-20 x 1/2" socket head cap screws
(F) and two 1/4" washers (H) in each bottom mounting slot.
(See Figure 4)
Figure 4
3.
The remainder of the mounting system installation may be
completed at this time, following the installation instructions
included with the mounting system.
11
5
6
4
12
x 4
(C) x 4
10
7 10
(B) x 2
(D) x 2
9
(D) x 2
13
13
(B) x 2
2
3
Mounting system
(not included)
(F) x 4
(H) x 4
(J) x 4
(A)
(G) x 4
